Applicable to the inspection of fuel cell MEA finished products, including size, appearance, thickness, air tightness, etc.

1.Detection accuracy: ± 0.8% of the reading+0.2% and measuring range.

2.Detection method: mass flow method.

Suitable for the preparation of electrolytic water slurry.

1.Size range of output slurry (d90): 5~20 μm (varies according to the solid content)

2.Mechanical slow mixing, high-speed shearing and ultrasonic dispersion three in one.

Be used for nanometer fine grinding for electrolytic water slurry.

1.Size range of output slurry (d90): 1~3 μm (varies according to the solid content)

2.Low slurry loss rate.

Applicable to integrated Machine for pre dispersion and nano fine grinding of catalyst slurry.

1.Integrated slurry tank and grinder, suitable for small batch preparation of electrolytic water catalyst. 

2.Optional 500ml dispersion cup, which can be combined with lifting platform for sample preparation. 

CCM and frame roll to roll continuous fit

1.Roll to roll continuous fit,High production capacity.

2.Online preparation of frame, no need to cut the border in advance.

Punch the frame and remove the waste.

1.Cutting accuracy  ≤±0.1mm

2.The mold accuracy  ±0.05mm

3.Thickness of SG incoming material  35-100um

Take the GDL sheet or coil stock into specified size.

1.Cutting accuracy  ≤±0.1mm

2.The mold accuracy  ±0.05mm

3.GDL incoming material thickness  120-280um

Repeat the loading of the frame on the other side manually,start the Machine to complete the second side bonding,the cut frame is aligned with CCM to form a five-layer membrane electrode assembly.

1.Non-defective product≥ 95%(Except for incoming materials and operation reasons)

2.The fitting accuracy with CCM frame ≤±0.3mm.

3.The fitting precision with the frame ≤±0.3mm.

By softening the material at high temperature and high pressure, the catalyst is embedded in the membrane material.

1.Accurate temperature control, tension control and rectification system based on.

2.The tension and roller support are used to flatten the material to the maximum extent, effectively avoiding the deformation of the material.

It is applicable to the catalyst for continuous and intermittent transfer printing of proton membrane roll on both sides.

1.Suitable for wide in width transfer printing, effective rolling width ≥ 400mm.

2.Rolling speed 0.5-5m/min.

3.It can adapt to gap transfer printing, and the straightness of product head and tail is high ≤± 0.3mm.